MEASURING INSTRUMENTS CATALOG No.E2019
464/608

Mitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.GG-29ProbeA sensor that converts movement of a contact point, on a stylus or plunger, into an electrical signal.Lever probesLever probes are available in two types. The most common type uses a pivoted stylus so the contact point moves in a circular arc; this type is subject to cosine effect and, therefore, measurements may require linearity correction if the direction of measurement is much different to the direction of movement of the contact point. The less common type uses a parallel translation leaf-spring mechanism so contact point movement is linear; this type requires no correction.Pre-travelThe distance from rst contact with a workpiece until the measurement indicator reads zero.Measuring forceThe force applied to the workpiece by the probe when the indicator registers zero. It is indicated in newtons (N).Digimatic codeA communication protocol for connecting the output of measuring tools with various Mitutoyo data processing units. This allows output connection to a Digimatic Mini Processor DP-1VA LOGGER for performing various statistical calculations and creating histograms, etc.Open collector outputA direct connection to the collector of a driving transistor.Relay outputContact signal that outputs an open/closed status.Comparative measurementA measurement method where a workpiece dimension is found by measuring the difference in size between the workpiece and a master gage that represents the nominal dimension.This method is usually applied when the measurement to be made is greater than the measuring range of the instrument. LinearityThe ratio of proportionality between measuring system output and measured distance. If this is not constant within acceptable limits then correction is required.0 (zero) pointA reference point on the master gage in a comparative measurement.Measurement rangeThe measurement range chosen determines the resolution available. A small range increases the resolution, and visa versa. Analog Mu-checkers provide multiple ranges because of the limited length of the scale, whereas digital versions only need to provide two.Tolerance settingTolerance limits can be set on the electronic micrometer to provide an automatic judgment as to whether a measured value falls within the tolerance.Electronic MicrometerQuick Guide to Precision Measuring InstrumentsPivoted stylus typeMLH-521 (measuring direction can be switched with the up/down lever)MLH-522 (measuring direction is not switchable)Parallel translation typeMLH-326 (measuring direction can be switched with the upper dial)First contact.Plunger moves until the indicator reads zero.0測定子がフリーの状態0測定子をメータが0になるまで押込んだ状態ゼロ

元のページ  ../index.html#464

このブックを見る