MEASURING INSTRUMENTS CATALOG No.E2019
322/608

E-31EMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.• Measures the length of rectangular gauge blocks in the size range 0.5 mm to 100 mm. It automatically compares a test block with an appropriate reference gauge block. • The compensation result is not affected by any warping of thinner gauge blocks due to the use of upper and lower gage heads (dual-head system). • Measurement conguration: 1 cycle of automatic comparison measurement with a standard gauge block.• Measures Rectangular Gauge Blocks and Square Gauge Blocks (latter requires dedicated holder - optional accessory) by manual comparison with an appropriate reference gauge block in the size range 0.1 mm to 250 mm• Measuring method: Differential measurement between upper and lower gage heads (dual head system)Gauge Block Comparator GBCD-100A SERIES 565 - Automatic Comparator with Dual Gage Heads Gauge Block Comparator GBCD-250 SERIES 565 — Manual Comparator with Dual Gage HeadsSpecial bridge-type blockGauge Block CalibrationLength Standards Brought to You by MitutoyoSPECIFICATIONSMetricRangeResolution (μm)Accuracy in narrow range(20 °C)Upper gaging headTypeMeasuring forceContact point0.5 mm - 100 mm0.01±(0.03+0.3L/1000) µm* L = Gauge block length (mm)Mu-Checker1 NCarbide contact point of radius 20 mmLower gaging headOperating conditionsTypeMeasuring forceContact pointMu-Checker0.6 NCarbide contact point of radius 5 mmTemperature: 20 °C ±1 °C Humidity: 58 %RH ±15 %RH* Uncertainty of measurement at the 95 % condence level (not including the calibration error of the reference gauge block).SPECIFICATIONSMetricRange (mm)ResolutionAccuracy (Confidence level 95 %)Comparison measurement of thesame nominal lengthAccuracy (Confidence level 95 %)Dimensional deviations betweenstandard gauge block andmeasurement gauge block: ±3 mm 0.1 - 2500.001 μm±(0.03+0.3L/1000) µm* L = Gauge block length (mm) ±(0.06+0.3L/1000) µm* L = Gauge block length (mm) Upper gaging head Lower gaging headOperating conditionsTypeMeasuring forceContact pointTypeMeasuring forceContact point Linear Gage0.4 NCarbide contact point of radius 20 mmLinear Gage0.2 NCarbide contact point of radius 5 mmTemperature: 20 °C ±1 °C Humidity: 30 %RH to 60 %RH* Uncertainty of measurement at the 95 % condence level (not including the calibration error of the reference gauge block).516-145-E2An inspection certicate is supplied as standard. Refer to page E-4 for details.An inspection certicate is supplied as standard. Refer to page E-4 for details.• Gauge block set for comparator calibration (optional) Standard type516-145-E2

元のページ  ../index.html#322

このブックを見る