■ Display mode types• Coordinate display (set value: 0)1-61• Sum/Difference calculation display (set value: 1)• Dual display (set value: 2)• Memory display (set value: 3)• Speed display (set value: 4) (EH-102P/EH-102Z/EH-102S only)Tips・ The origin and tolerance can be set separately for INPUT A and INPUT B.Tips・ Set sum (A + B) or difference (A - B) by parameter number 14.・ Connect Linear Gages that have the same resolution to INPUT A and INPUT B.Tips・ The memory unit is shared between BANK1 and BANK2. Connect Linear Gages that have the same resolution.・ The B_HOLD signal can be used to write to or clear the memory externally.Tips・ Specify the speed sampling cycle by parameter number 18.・ The value is displayed in mm/sec. The display of the last 1 to 3 digits may be fixed depending on the speed sampling cycle.・ The maximum speed in the reverse direction is displayed when the minimum value (MIN) is selected in Peak mode.・ This type is not applicable to feedback control.Displays 2 sets of coordinates using the BANK function.Displays the Sum/Difference calculation for thickness or step measurement.In Peak mode measurement, the peak value and the counter value of one Linear Gage are displayed simultaneously. The peak value is displayed on Display A, and the counter value is displayed on Display B.You can switch between INPUT A and INPUT B using the BANK function.Saves the current value on Display A in Display B. In addition to the most recently saved data, the maximum value and the minimum value from past data can also be read out. The saved data will not cleared even if the power switch is turned off.Displays the moving speed of the Linear Gage's spindle simply.In addition to the current speed, it displays the maximum speed when the maximum value (MAX) is selected in Peak mode.Counter Specifications
元のページ ../index.html#78