MEASURING INSTRUMENTS CATALOG No.E2016
388/682

F-47FMitutoyo operates a policy of continuous improvement that aims to provide the customer with the benet of the latest technological advances.Therefore the company reserves the right to change any or all aspects of any product specication without notice.SERIES 2 — Special Dial IndicatorsAdjustable hand dial gauge● The hand position can be adjusted independently of the position of the spindle by rotating the top knob.2048S-10Dial IndicatorsComparison measuring instruments which ensure high quality, high accuracy and reliability.An inspection certicate is supplied as standard. Refer to page X for details.ø6.5M2.5×0.45M2.5×0.4519.516.9ø57ø57202048S-102046S-8017.77.61647.464.9ø52ø6.515.116.919.82017.77.61659.865.252øø8 0-0.009ø8 0-0.00955Clearance ofpeak holdDIMENSIONS Unit: mmISO/JIS TypeFEATURESMetricOrder No.——w/ lugFlat-back2048S-102048SB-104—4——InchOrder No.——w/ lugFlat-back2915S-102915SB-104—4——2918S-102918SB-104—4——SPECIFICATIONSMetricOrder No.GraduationRange (range/rev)AccuracyRepeat-abilityDial readingMeasuring forcew/ lugFlat-backOverallRetrace1/10 Rev1 Rev2048S-102048SB-100.01mm10mm (1mm)15µm3µm5µm10µm3µm±0-1001.4N or lessISO/JIS typeInchOrder No.GraduationRange (range/rev)AccuracyRepeat-abilityDial readingMeasuring forcew/ lugFlat-backFirst 1 Rev / 2.5 Rev / 10 RevRetrace2915S-102915SB-10.001”.5” (.1”)±.001” / ±.001” / ±.001.0002±.0002±0-1001.8N or less2918S-102918SB-10.001”.5” (.1”)±.001” / ±.001” / ±.001.0002±.00020-50-01.8N or lessANSI/AGD type* Contact points, other than dedicated types, cannot be installed.* The shoulder on a contact point (standard accessory) acts as a stop to prevent spindle overrun that may otherwise damage the indicator. For this reason, if you need to install an optional contact point with an outside diameter smaller than 7mm, use a washer (with outside diameter of at least 7mm, inside diameter of 3mm, and thickness of approx. 0.5mm) placed between the contact point and the spindle.* Completed products inspection is performed in the vertical position (contact point downward) and the stated accuracy is guaranteed.* Completed products inspection is performed in the vertical position (contact point downward) and the stated accuracy is guaranteed.

元のページ 

page 388

※このページを正しく表示するにはFlashPlayer10.2以上が必要です