MEASURING INSTRUMENTS CATALOG No.E2016
319/682

E-30EMitutoyo operates a policy of continuous improvement that aims to provide the customer with the benet of the latest technological advances.Therefore the company reserves the right to change any or all aspects of any product specication without notice.• Alumina-ceramic abrasive stone for removing burrs from hard materials such as ceramics that ordinary stones cannot handle.• Can be used both for steel gauge blocks and CERA blocks.• Excellent in the ease of removing burrs and durability compared with Arkansas stones. • Both sides can be used. CerastonSERIES 516 — Accessory for Gauge Block Maintenance 601644150 (W) ×50 (D) ×20 (H) mm601645100 (W) ×25 (D) ×12 (H) mm(1) Wipe any dust and oil lms from the gauge block and the Ceraston (or Arkansas stone) using a solvent.(2) Place the gauge block on the Ceraston so that the measuring face that has burrs is on the abrasive surface of the stone. While applying light pressure, move the gauge block to and fro about ten times (Fig. 1). Use a block rubber for thin gauge blocks to apply even pressure (Fig. 2).(3) Check the measuring face for burrs with an optical at. If the burrs have not been removed, repeat step (2). If burrs are too large, they may not be removed with an abrasive stone. If so, discard the gauge block.*1 Mitutoyo does not offer Arkansas stones. Removing burrsFigure 1Figure 2Application exampleCERASTON (Or Arkansas stone*1)RubberCERASTON (Or Arkansas stone*1)CERASTON (Or Arkansas stone*1)RubberCERASTON (Or Arkansas stone*1)

元のページ 

page 319

※このページを正しく表示するにはFlashPlayer10.2以上が必要です