MEASURING INSTRUMENTS CATALOG No.E2016
315/682

E-26EMitutoyo operates a policy of continuous improvement that aims to provide the customer with the benet of the latest technological advances.Therefore the company reserves the right to change any or all aspects of any product specication without notice.Half round jaw•Contraction caused by the clamping forceThe minimum recommended torque to be applied to the clamping screws is approximately 600mN/m. The chart below shows the approximate length contraction of a 100mm gauge stack using typical torque values.Flat head screwAdjustable tie rodTie rod• Flatness tolerance 0.12μm• Parallelism tolerance 0.12μm• A and B are nished surfacesPlain jaw 619072Slotted head nut 619059• Parallelism tolerance 1.5μm• Flatness tolerance 1.5μm The surface within 1.5mm(of edge is excluded )Base 619074Scriber point 619054• Flatness tolerance 0.5μmCenter point 619073Stud 619056Knurled head screw619066R24.7WLHø6.7Finished surface39.924.75.14Within 7.5µmø6.7Finished surface16ø4.1668-32UNCP=8-39.9ø6.7AB910±0.00124.75810±0.0005Finished surfaceø6.7Finished surface15.88-32UNCNo.8-32UNCd=4.166 P=0.7938ø6.3530128-32UNCøNo.8-32UNCd=4.166 p=0.7938ø92±0.017.8Finished surface24.739.9ø6.78-32UNCNo.8-32UNCd=4.166 P=0.7938LPø6.35n (Number of holes)8-32UNCd=4.166 P=0.7938Lø6.35P×nMPLd=4.166 P=0.7938No.8-32UNCn (Number of holes)ø6.358-32UNCLd=4.166 P=0.7938Stud Order No.RLWH6190701.95mm2mm33.6mm5.3mm6190714.95mm5mm39.9mm10.3mm• Flatness tolerance 0.5μm• Parallelism tolerance of L 0.5μm• Tolerance of L ±0.5μmOrder No.LMPn619060124.5mm3.85mm6.35mm1461906186.5mm3.95mm6.35mm8Order No.L61905731.6mm61905815.8mmDriverContractionTorque Driver600mN·m0.2μm/100mmOrdinary Driver700 - 800mN·m0.3μm/100mmOrder No.L61906519mm61906438mm61906357mm61906276mmAccessories used for combining square gauge blocksOverall length (mm)Min.213634414558647277829195109117130148121167143160205180223240258295375Order No.Included in setMax.30434350607279889197107109125135150169180184210255270285288345363445520619059Slotted head nut 111619058Flat head screw 1212121211226190571121212122222222222619056Stud 11111111112619065Tie rod 1111619064111161906311116190621111111619061Adjustable tie rod 222222619060222222

元のページ 

page 315

※このページを正しく表示するにはFlashPlayer10.2以上が必要です