MEASURING INSTRUMENTS CATALOG No.E2016
272/682

D-53DMitutoyo operates a policy of continuous improvement that aims to provide the customer with the benet of the latest technological advances.Therefore the company reserves the right to change any or all aspects of any product specication without notice.• Enables efcient setting and inspection of calipers and height gages.CERA Caliper CheckerSERIES 515Outside measurementInside measurement515-555Outside measurementInside measurement515-556-2515-555205010015020030050150200250300INSIDE25010020mm05063539374.563535092050100150200300400500550600mm050100150250350450500550600INSIDE450200350300250400206846003003002502502002001501501001005050202055050045035025015010050201501002050CC-600C600550500450350250150100502020501001502003004005506005006006005505505005004504504004003503503003002502502002001501005020515-556-2Height GageA standard measuring tool of industryAn inspection certicate is supplied as standard. Refer to page X for details.InchOrder No.RangeBlock pitch accuracy*Parallelism of blocks*Mass1 - 12”1 - 12”515-5650 - 12”±.0002".00008"4kg* The block accuracy and the parallelism of blocks are based on the following: Outside caliper and height gage: lower end reference plane Inside caliper: inside reference planeSPECIFICATIONSMetricOrder No.RangeBlock pitch accuracy*Parallelism of blocks*Mass20 - 300mm350 - 600mm20 - 300mm350 - 600mm515-5550 - 300mm±5.0µm—2.0µm—4kg515-556-20 - 600mm±7.0µm4.0µm8.5kg* The block accuracy and the parallelism of blocks are based on the following: Outside caliper and height gage: lower end reference plane Inside caliper: inside reference planeDIMENSIONS Unit: mmOptional accessories602162: Wooden case for 300mm, 12inch model602164: Wooden case for 600mm model ApplicationsChecking accuracy of caliper (inside measurement)Checking accuracy of height gaugeChecking accuracy of caliper (outside measurement)515-555Alternative solution using a Square Gauge Block Accessories SetIf such an accessories set is available, then an instrument equivalent to the CERA Calibration Checker may be assembled, as shown below, if additional elements are obtained (particularly plain jaws, 619072). For details, refer to pages E-25/26. Note that such an assembly will not have the corrosion resistance of the CERA Calibration Checker and, therefore, more care will be required in use and storage.

元のページ 

page 272

※このページを正しく表示するにはFlashPlayer10.2以上が必要です