MEASURING INSTRUMENTS CATALOG No.E2016
168/682

B-115BMitutoyo operates a policy of continuous improvement that aims to provide the customer with the benet of the latest technological advances.Therefore the company reserves the right to change any or all aspects of any product specication without notice.B-115B■Maximum Loading Capacity of Micrometer HeadsThe maximum loading capacity of a micrometer head depends mainly on the method of mounting and whether the loading is static or dynamic (used as a stop, for example). Therefore the maximum loading capacity of each model cannot be denitely specied. The loading limits recommended by Mitutoyo (at less than 100,000 revolutions if used for measuring within the guaranteed accuracy range) and the results of static load tests using a small micrometer head are given below.Test methodMicrometer heads were set up as shown and the force at which the head was damaged or pushed out of the xture when a static load was applied, in direction P, was measured. (In the tests no account was taken of the guaranteed accuracy range.)1. Recommended maximum loading limit2. Static load test for micrometer heads (using 148-104/148-103 for this test)(1) Clamp nut (2) Split-body clamp(3) Setscrew clamp PClamp nutSplit-body clampPSetscrewPMaximum loading limitStandard typespindle pitch: 0.5mmUp to approx. 39.2N (4kgf)*High function typeSpindle pitch: 0.1mm/0.25mmUp to approx. 19.6N (2kgf)Spindle pitch: 0.5mmUp to approx. 39.2N (4kgf)Spindle pitch: 1.0mmUp to approx. 58.8N (6kgf)Non-rotating spindleUp to approx. 19.6N (2kgf)Series 110 micro-ne feed type (with a differential mechanism)Up to approx. 19.6N (2kgf)* Up to approx. 19.6N (2kgf) only for Ultra small modelsMounting methodDamaging / dislodging load*(1) Clamp nut Damage to the main unit will occur at 8.63 to 9.8kN (880 to 1000kgf).(2) Split-body clampThe main unit will be pushed out of the xture at 0.69 to 0.98kN (70 to 100kgf).(3) Setscrew clamp Damage to the setscrew will occur at 0.69 to 1.08kN (70 to 110kgf).* These load values should only be used as an approximate guide.

元のページ 

page 168

※このページを正しく表示するにはFlashPlayer10.2以上が必要です