|
 
Engine block |
| How to automatically measure the dimensions of the engine block inline. |
 |
|
| Engine block |
| I want to measure the roughness of the engine block, without having to wait for the long period required by the heavy load. |
|
|
| Crankshaft, camshaft |
| Roughness cannot be measured in the axial direction on site. |
|
|
| Car body |
| How to perform efficient, non-contact measurement of car bodies. |
|
|
| Door, hood, bumper |
| I want to efficiently measure steps and gaps on site. |
|
|
|
Rubber roller |
| How to perform non-contact measurement of the outside diameter of rubber rollers, run-out, and ellipticity. |
|
|
| Connector |
| How to perform dimension measurement with a projector and microscope, while increasing the measurement efficiency. |
|
|
| Optical communication connector |
| I cannot measure small holes, such as in optical communication connectors. |
|
|
| Liquid crystal |
| How to measure liquid crystals with a large measurement range. |
|
|
| Pin gage, plug gage |
| How to test pin gages and plug gages at high speed and with high accuracy. |
|
|
| Aspherical lens |
| How to perform high-accuracy measurement of the form of aspheric lenses. |
|
|
|
Ball end mill |
| How to perform non-contact measurement of tip R of ball end mills. |
|
|
| Screw lead, ball screw |
| How to perform efficient measurement of the dimensions of screw leads and ball screws. |
|
|
|
O-ring, film |
| Accurate measurement is not possible because of the softness of the material. |
|
|
|
|
|
